Receiver Panel Descriptions, IR Receiver

RECEIVER PANEL DESCRIPTIONS

1Locking 5V DC Power Supply Input

When using a 5 BNC cable system this connector will not need to be used. When using a 4 BNC cable system a second 5V DC power supply (part# EXT- PS52AU) must be purchased and connected to this input port.

2IR Receiver

This receiver is used for the IR Repeater feature. This receiver will accept standard IR remote commands for transmission back to the sending unit and then to the connected IR emitter/blaster.

3HDMI Output Port

Connect the HDMI capable display device to this output port. A secure connection to this HDMI port can be made using Gefen Mono•LOK cables.

4IR Extension Port

An IR receiver extension (sold separately, part# EXT-RMT-EXTIR) can be connected to this port to relocate the IR receiver. This option is available so that the receiving unit can be placed out-of-sight while still retaining the usability of the IR Repeating feature.

5Link LED Indicator

This LED indicator will become active once a valid link has been established between the sending and receiving units. If this LED does not activate there is a possible mis-connection between the two units.

6Red BNC Connector

This connector will transmit the RED signal data to the receiving unit. The cable used for this connection cannot be omitted.

7Green BNC Connector

This connector will transmit the GREEN signal data to the receiving unit. The cable used for this connection cannot be omitted.

8Blue BNC Connector

This connector will transmit the Blue signal data to the receiving unit. The cable used for this connection cannot be omitted.

9Clock BNC Connector

This connector will transmit the CLOCK signal data to the receiving unit. The cable used for this connection cannot be omitted.

10Receiver Power BNC Connector

This connector will transmit the power needed to operate the receiving unit. The cable used for this connection can be omitted when using a 4 BNC type of cable setup. If this cable is omitted power must separately be supplied to the receiver by one of the included 5V DC power adapters.