Connecting and Operating the Hdmi Over RGB

CONNECTING AND OPERATING THE HDMI OVER RGB

How to Connect the HDMI Over RGB

1.Connect the HDMI source device to the HDMI Over RGB sender unit using the supplied HDMI cable.

2.The HDMI Over RGB sender and receiver can be used with either a user supplied 4 or 5 BNC cable system.

5 BNC Cables

Connect all 5 BNC cables to the R, G, B, C, and RP BNC connectors between the HDMI Over RGB sender and receiver units.

4 BNC Cables

Connect the 4 BNC cables to the R, G, B, and C BNC connectors between the HDMI Over RGB sender and receiver units. The RP BNC connector will not be used and a second power supply (part# EXT-PS52AU) will need to be purchased and connected to the receiver unit.

3.Connect the HDMI capable display device to the HDMI Over RGB receiver unit using a user supplied HDMI cable.

4.Connect the included 5V DC power adapter to the HDMI Over RGB sender unit.

NOTE: If using a 4 BNC cable system, a second power supply must be purchased and connected to the HDMI Over RGB receiver unit.

5.Power on the display ﬁrst and then the source.

How to Operate the HDMI Over RGB

The HDMI Over RGB does not require any conﬁguration for standard operation.

IR Repeater Feature

An IR emitter/blaster (sold separately, part# EXT-2IREMIT) is required to send relayed IR commands to equipment at the sender’s location. Connect the IR emitter jack to the HDMI Over RGB sender unit and connect the IR “eye” on or near the IR receiver of the equipment that is intended for control. Point the equipment’s IR remote at the IR receiver on the HDMI Over RGB receiver unit and press buttons to relay commands back to the equipment device.