Gefen EXT-COMPAUD-CAT5-444 user manual Operating the 4X4 Component Matrix Over CAT-5 Receiver

Page 16

OPERATING THE 4X4 COMPONENT MATRIX OVER CAT-5 RECEIVER

The 4x4 Component Matrix Over CAT-5 Receiver can be placed at each remote location. Each receiver can switch between the four sources connected to the 4x4 Component Over CAT-5 Matrix sender. The unit has two methods of switching using either the direct selection buttons or the RMT-4IR remote control.

Switching Using The Direct Selection Buttons

Each numbered button on the top panel of the 4x4 Component Matrix Over CAT-5 Receiver corresponds to component inputs 1 through 4 on the 4x4 Component Matrix Over CAT-5 sending unit.

1.Press the button on the top panel of the receiver that corresponds to the input that you wish to view.

Switching Using The Direct Selection Buttons

The RMT-4IR remote has 4 numbered buttons that correspond to inputs 1 through 4 on the 4x4 Component Matrix Over CAT-5 sender unit.

1.Press the button on the RMT-4IR remote control that corresponds to the input that you wish to view.

Using the IR Repeater Feature

Each 4x4 Component Matrix Over CAT-5 receiver can receive commands from standard consumer IR remote controls and send them back to the sender unit for output through the IR emitters/blasters. This allows the user to control the equipment connected to the sender from the remote location. The IR emitters (part# EXT- 2IREMIT) are sold separately.

1.Connect an IR blaster to the IR Blaster output port on the rear panel of the 4x4 Component Matrix Over CAT-5 sender unit. Each of the 4 numbered output ports correspond to each of the 4 CAT-5 extension ports. Connect the IR emitter to the same port number of the remote receiver that you wish to use.

2.Remove the adhesive from the IR blaster’s emitter eye and place it on or near IR receiver of the connected equipment.

3.Using the IR remote control of the equipment that has the IR emitter attached to it, send commands to the 4x4 Component Matrix CAT-5 receiver at the remote location. These IR command will be routed back to the sender and output through the IR blasters to control the attached source device.

13

Image 16
Contents CAT-5 Asking for Assistance Technical SupportTechnical Support Hours Write ToContents Introduction GefenGefen 4x4 Component Matrix Over CAT-5 How It WorksOperation Notes Features Package Includes4X4 Component Matrix Over CAT-5 Front Panel Layout 4X4 Component Matrix Over CAT-5 Front Panel Descriptions 4X4 Component Matrix Over CAT-5 Back Panel Layout 4X4 Component Matrix Over CAT-5 Back Panel Descriptions 4X4 Component Audio Over CAT-5 Receiver Panel Layout Front Panel Back Panel Top Panel4X4 Component Audio Over CAT-5 Receiver Panel Description LED Indicator RMT-16IR Remote DescriptionEmpty Battery Slot IR Code Dip Switches LED Indicator Input Selection ButtonsRMT-4IR Remote Description How to Connect the 4x4 Component Matrix Over CAT-5 Using the IR Repeater Feature Switching Using The Direct Selection ButtonsOperating the 4X4 Component Matrix Over CAT-5 Receiver Brightness Adjusting the 4X4 Component Matrix Over CAT-5 ReceiverFocus RMT-4IR Remote IR Code Configuration How to Resolve IR Code ConflictsRS-232 Serial Control Interface RS232 SettingsBinary Table Network Cable Wiring Diagram Pin ColorRack Mount Installation Specifications