RMT-4IR Remote IR Code Configuration

How to Resolve IR Code Conﬂicts

In the event that IR commands from other remote controls conﬂict with the supplied RMT-4IR remote control, changing the remote channel will alleviate this issue. The RMT-4IR remote control and the 4x4 Component Matrix Over CAT-5 receiver have DIP SWITCHES for conﬁguring the remote channel that both units use to communicate. These settings must match each other for proper operation. The 2 DIP SWITCH bank on the RMT-4IR is located underneath the battery cover. The 4 DIP SWITCH bank for the 4x4 Component Matrix Over CAT-5 receiver is located on the underside of the unit beneath a black piece of metallic tape. DIP SWITCH 1 and 2 on the RMT-4IR correspond to *DIP SWITCH 1 and 2 on the 4x4 Component Matrix Over CAT-5 receiver.

NOTE: *DIP SWITCHES 3 and 4 are not used on the 4x4 Component Matrix Over CAT-5 receiver.

Remote

Remote Channel 1:		Remote Channel 2:
Remote Channel 1:		Remote Channel 2:
Default


1	2	1	2

Remote Channel 3:		Remote Channel 4:




1	2	1	2

Remote Channel 1: Default

Remote Channel 3:

4x4 Component Matrix Over CAT-5 receiver

	Remote Channel 2:
1 2 3 4	1 2 3 4
	Remote Channel 4:
1 2 3 4	1 2 3 4