Section 5 — Electrical Data
ATS “HS” Type Transfer Switch
Transfer Switch Interconnections - Drawing No.
UTILITY
METER
SOCKET
INSULATED SPLICING CONNECTOR OR (NEW WIRES CAN BE PULLED FROM ATS & PANELBOARD).
IF ATS IS USED AS SERVICE ENTRANCE
DEVICE A BONDING JUMPER WILL NEED
TO BE INSTALLED SIZED TO MEET
NATIONAL & LOCAL CODES.
SERVICE DISCONNECT
ATS
E2 |
|
T2 | NOTE: INSTALLATION TO BE DONE BY A |
E1 |
EXISTING WIRES TO PANELBOARD (SEE ABOVE NOTE)
22 
33
11
44
E1 E2
LICENSED ELECTRICIAN AND MUST MEET ALL NATIONAL, STATE AND LOCAL ELECTRICAL CODES.
FROM
ALTERNATOR
STATOR
NEUTRAL BAR
DISCONNECT
BONDING
CONNECTION
IN PANELBOARD
GROUND BAR
PANELBOARD
N1 |
|
N2 | |
T1 * | |
T2 * | USED ON AIR COOLED UNITS |
|
23AND SOME LIQUID COOLED UNITS
RETROFIT
AC GENERATOR
CONTROL PANEL
9