Farallon Communications NetLINE manual Installing the Hardware

Page 8

8 CHAPTER 2

INSTALLING THE HARDWARE

Begin installation by connecting the card. Then insert the card in the computer’s PC card slot.

1.Hold the PC card and connector so that the arrow is facing up.

2.Insert the flat end of the connector into the end of the PC card until you hear a small click.

TOP

TO

 

RELEASE

PRESS

TOP

TO

 

 

RELEASE

PRESS

CAUTION: Use care when detaching the connector from the PC Card. Pulling the connector from the card without squeezing the sides may cause severe damage to the card and connector and may void your warranty. Do not pull the PC card out of the PC card slot by pulling on the connector cable.

Image 8
Contents Farallon 6120370-00-01 Contents Page Introduction Features Installation Installing the Hardware Installation Installing the Software WindowsTCP/IP Windows Windows NT Connecting to the Network Operation Netline Card Leds Diagnostic Utility EepromPage Farallon Technical Support Chapter Specifications AppendixRegulatory Notices FCC Compliance StatementCE Mark Vcci CertificationPage Warranty Limited Warranty and Limitation of Remedies