Profile HA1000 installation instructions TWO Channel Signal Connections

Page 9

SIGNAL CONNECTIONS

Connect the RCA output of the head unit (AM/FM cassette player, CD, or DAT) to the RCA input terminals of the amplifier.

To make these connections, we recommend high quality RCA cables, which are available at your local car audio retailer. Run signal wires away from electrical wires to avoid possibility of induced noise from the car's electrical system (i.e. popping noises or engine noise). Please note that when making these connections the signal inputs correspond with the speaker outputs.

For example: If you connect the radios front right RCA to "CH 1" .......then speaker output

"CH 1" will operate the front right speaker.

TWO CHANNEL SIGNAL CONNECTIONS

FOUR CHANNEL SIGNAL CONNECTIONS

(RADIO WITH FRONT AND REAR OUTPUTS)

FRONTREAR

FOUR CHANNEL SIGNAL CONNECTIONS

(RADIO WITH ONLY ONE SET OF RCA'S)

Connect 2 sets of RCA "Y" adaptors to split the two RCA's from the radio into 4 outputs (Not Provided)

8

Image 9
Contents Mosfet Power Amplifiers Introduction Keep Your Sales ReceiptRecommendation Safety Precautions Features and Benefits Power and Speaker Terminals Adjustable Input SensitivityTri-Mode Capable Excluding HA700M & HA1000M models Remote Turn-onProtection Indicator Short Circuit ProtectionThermal Protection Connect the B+ terminal of the amplifier to the cars battery Power ConnectionsMounting Location TWO Channel Signal Connections Signal ConnectionsHigh Level Connections Optional Speaker Connections Speaker Connections Bridged Speaker Connections TRI-MODE Setting the Crossover and BASS/TREBLE Boost Low Pass Setting with Bass BoostHigh Pass Setting with Treble Boost Setting the Gain Using Subsonic Filter and Phase ControlLook for Solution Trouble Shooting the SystemSpecifications HA400 HA600 HA1000HA740 HA1040 HA700M HA1000M Limited Warranty Warranty Repair Policy