Extreme Networks Px Series manual 1Px series application switch LEDs, Color Indicates

Table 2-1 describes the LED behavior on the SummitPx1.

Table 2-1:Px series application switch LEDs

LED	Color		Indicates
Link	Green		The 1000Base-T link is operational.
	Yellow flashing		There is activity on this link.
Management	Green flashing
	■	Slow	The Px series application switch is operating normally.
	■	Fast	Power On Self Test (POST) in progress.
	Red		The Px series application switch has failed its POST.
Power	Green		The Px series application switch is powered up.
	Red		The Px series application switch is indicating a power or
			temperature problem.

The front panel of the SummitPx1 has four ports:

•Gigabit Interface Connector (GBIC)

The Network Interface port is a Gigabit Interface Connector (GBIC) used to connect the application switch to your local network.

•100BASE-Tx Ethernet Management (RJ-45)

The Ethernet Management port (RJ-45 connector) is a 10/100 Mbps Ethernet connection used for out-of-band management.

•Console (serial RJ-45)

The console port (serial RJ-45 connector) is used to connect a terminal for local out-of-band management. The console operates at 9600 baud, 8 data bits, no parity, one stop bit (8-N-1) with no hardware flow control.

Use the included DB-9 adapter to connect the console to a PC serial port, using a straight (1-8, 1-8) cable, such as a standard category 3 or category 5 Ethernet cable. The pinouts for the DB-9 adapter are shown in Table 2-2 on page 2-3.

If you are wiring the console port to a console server, you must use a null modem cable (1-8, 8-1).

•AUX (serial RJ-45)

The AUX port (RJ-45 connector) has the same pin-outs as the console port. The AUX port is used for remote out-of-band management.

2-2 Px Series Application Switch Installation and Configuration Guide