Encore electronic ENLWI-NX2 manual Configuration

Page 12
Configuration

Link Quality: Shows the link quality of the Wireless N PCI Adapter with the Access Point when operating under Infrastructure mode.

Signal Strength: Shows the wireless signal strength of the connection between the ENLWI-NX2 Wireless 802.11n PCI Adapter with the Access Point.

Data Rate: Shows the statistics of data transfer, and the calculation is based on the number of packets transmitted and received.

Configuration

This screen is where you set the basic wireless settings for the ENLWI-NX2 Wireless 802.11n PCI Adapter.

Profile Name: Shows the Profile Name.

SSID: Service Set Identifier, which is a unique name shared among all clients in a wireless network. The SSID must be identical for each client in the wireless network.

Wireless Mode: There are two modes available for selection

Infrastructure – to establish wireless communication with the LAN and other wireless clients through the use of Access Points.

Ad-Hoc – to establish point-to-point wireless communication directly with other wireless client devices.

8

Image 12
Contents IEEE 802.11n 2.0 Draft Wireless LAN PCI Adapter User’s Guide ENLWI-NX2Federal Communication Commission Interference Statement IMPORTANT NOTE FCC Radiation Exposure StatementEurope - EU Declaration of Conformity EN 60 950-1 2001 +A110560 Česky Czech Dansk Danish Deutsch German Eesti Estonian EnglishTechnical Specifications IntroductionTABLE OF CONTENT Unpacking and SetupINTRODUCTION Overview of this User’s GuideUNPACKING AND SETUP SetupUnpacking Check the installation IDENTIFYING EXTERNAL COMPONENTSLink ACT ActivitySOFTWARE INSTALLATION Windows Based Utility InstallationPage 3 Click Finish to finish the installation and to restart the computer ENLWI-NX2 WIRELESS UTILITY SETTING Link InformationConfiguration Open or Shared Key WPA-PSK / WPA2-PSKWPA EAP-TLS Site Survey Profile Push the button on my access point 5 If the WPS configuration was failed, the follow window will show on Enter a PIN into my access point 5 If the WPS configuration was failed, the follow window will show on About TECHNICAL SPECIFICATIONS WirelessHardware