Encore electronic ENLWI-NX2 manual Software Installation, Windows Based Utility Installation

Page 8

SOFTWARE INSTALLATION

This section describes how to install the driver and utility for the ENLWI-NX2 802.11n Wireless LAN PCI Adapter. This can be done prior to the hardware installation.

Windows Based Utility Installation

1) Insert the Utility and Driver CD-ROM into your computer’s C

2) Follow the Install Shield Wizard Instructions below

Image 8

Contents IEEE 802.11n 2.0 Draft Wireless LAN PCI Adapter User’s Guide ENLWI-NX2Federal Communication Commission Interference Statement IMPORTANT NOTE FCC Radiation Exposure StatementEurope - EU Declaration of Conformity EN 60 950-1 2001 +A110560 Česky Czech Dansk Danish Deutsch German Eesti Estonian EnglishTechnical Specifications IntroductionTABLE OF CONTENT Unpacking and SetupINTRODUCTION Overview of this User’s GuideUnpacking UNPACKING AND SETUPSetup Check the installation IDENTIFYING EXTERNAL COMPONENTSLink ACT ActivitySOFTWARE INSTALLATION Windows Based Utility InstallationPage 3 Click Finish to finish the installation and to restart the computer ENLWI-NX2 WIRELESS UTILITY SETTING Link InformationConfiguration Open or Shared Key WPA-PSK / WPA2-PSKWPA EAP-TLS Site Survey Profile Push the button on my access point 5 If the WPS configuration was failed, the follow window will show on Enter a PIN into my access point 5 If the WPS configuration was failed, the follow window will show on About Hardware TECHNICAL SPECIFICATIONSWireless