
Windows Me/98 users
1.With the
Do not connect the
2.Exit all currently running software.
Also close any open windows. If you are using virus checking or similar software, be sure to exit it as well.
3.Prepare the
Insert the
4.Click the Windows Start menu. From the menu that appears, select Run....
The “Run...” dialog box will appear.
5.In the dialog box that appears, input the following into the “Open” field, and click [OK].
D: \Driver\Me98\Setup.exe
*The drive name is “D:” in the example shown here, but may be different on your system. Use the drive name for your
6.The Driver Setup dialog box will appears. Click [Next].
7.To begin the installation, click [Next] once again. Installation will begin. The “Setup is now ready to install the drivers” dialog box will appear. Now you are ready to install the driver.
8.Operation of the
*The driver cannot be installed by means of the following procedure if the switch is set to OFF.
If you are using Windows 98/Me/2000/XP or XP SP1, you must turn the ADVANCED (mode select) Switch ON before you connect the
9.Operation of the
*This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UM- 1EX is required before the unit will operate normally.
10.In the Driver Setup dialog box, click [Close].
Next, you’ll make the driver settings. (➔ “Setting the Driver” (p. 18))
17