Datacom Systems SS series SPAN, VS series SPAN, VS series Multi-Link manual LED Display Code

24 Datacom Systems Inc

To connect the VERSAstream™ VS-1022BT-BT SPAN Series aggregator/regenerator, refer to Figure 15 and follow these steps:

1.Two power supplies are provided. Use of the second power supply is strongly recommended to assure uninterrupted monitoring. Connect both power supply barrel connectors into the power 1 and 2 ports, respectively, of the VERSA- stream™. Plug the power supplies into the external power source, furthermore, connecting the second power supply to a different external power source circuit than the first power supply eliminates power as a single point of failure. The POWER 1 and 2 LEDs illuminate indicating power 1 and 2, respectively, are on. Either LED not illuminated indicates a defective power source and immediate replacement is required to insure redundant power integrity.

2.Connect network cables to the VERSAstream™ RJ45 NETWORK ports. The NETWORK RJ45 left integrated LED is solid green indicating link has been established on the port. The LED Display Code table deciphers the RJ45 jacks with integrated LEDs that display line status and line speed of each port.

LED Display Code

Code

Link Data

Left LED

Solid Green

Flashing Green

WITH LINK OR DATA

Right LED

Green

Orange

OFF

Code

1,000 Mbs

100Mbs

10Mbs

3.Connect analysis devices to the VERSAstream™ RJ45 MONITOR ports. The MONITOR RJ45 left integrated LED is solid green indicating link has been established on the port. The LED Display Code table deciphers the RJ45 jacks with integrated LEDs that display line status and line speed of each port.

SPAN and Multi-Link Aggregators/Regenerators • USERguide