CyberPower Systems Network Management Card user manual Ups

CyberPower Network Management System

[UPS Reboot] allows advanced remote control of the UPS. Select one function by clicking its button. Click [Apply] to begin the operation. Select [Cancel] to refresh the selection.

Note: The commands in [UPS Reboot] menu may change by the settings in the [UPS Schedule] menu.

Commands	Definition
Reboot UPS Immediately	To turn the UPS off and then on again.
Delay 03 min(s) to Reboot	3 minutes is a default value. The user may select any
	number between 1-99. The UPS will shut off and wait
UPS
	the set amount of time before turning back on.
Cancel Reboot UPS	To stop the previous command “Delay 03 min(s) to
	Reboot UPS.
Turn Off UPS Immediately	To turn the UPS off immediately.
Delay 03 min(s) to Turn Off	3 minutes is a default value. The user may select any
	number between 1-99. The UPS will wait the set
UPS
	amount of time before turning OFF.
Cancel Turn Off UPS	To stop the previous command “Delay 03 min(s) to
	Turn Off UPS
Turn On UPS Immediately	To turn on UPS when it is turned off.

10