CyberPower Systems Official Power Supply Manual -

Page 17

FCC Notice

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction.

CAUTION: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interfer- ence to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment.

CAUTION: Any changes or modifications not expressly approved by the guarantee of this device could void the user’s authority to operate the equipment.

For more information, contact us at:

CyberPower Systems (USA), Inc.

5555 12th Avenue East, Suite 110

Shakopee, MN 55379

Tel: (952) 403-9500

Fax: (952) 403-0009

Toll-Free: (877)-297-6937

Email: sales@cyberpowersystems.com

Web: www.cyberpowersystems.com

Entire contents copyright ©2003 CyberPower Systems, Inc.

All rights reserved. Reproduction in whole or in part without permission is prohibited. PowerPanel™ is a trademark of CyberPower Systems (USA), Inc.

Image 17
Contents Additional Installation Tips can be Found AT Table of Contents Description Guaranteed Uninterruptible Power SystemOverview HOW to Determine the Power Requirements of Your EquipmentHardware Installation Guide USB Function Optional Installation GuideFor Windows 95 /98 /ME For Windows NTPowerPanel Main Window Description See Figure PowerPanel Setup Window See FigureOprating Instruction For Windows XP Home and ProfessionalUsing the Windows 2000 UPS Service PowerPanel Shutdown Window See FigureUsing the Windows NT UPS Service If you are using PowerPanel software Testing Your UPS SystemCondition Definitions for Illuminated LED IndicatorsAdditional troubleshooting information can be found at Trouble ShootingExpected Runtime in Minutes SpecificationsExclusive Remedies Under Limited Warranty Limited Warranty and Power Control GuaranteeMaking a Power Control Guarantee Claim Making a Limited Warranty ClaimCyberPower’s Duties Exclusion of Consequential and Other Damages Page Email sales@cyberpowersystems.com