CyberPower Systems CPS725SL user manual Definitions for Illuminated LED Indicators, Condition

CPS725SL

Guaranteed Uninterruptible Power System

7.Disconnect the battery wires from the battery.

8.Install the replacement battery by connecting the red wire to the positive (+) terminal of the battery and connecting the black wire to the negative (-) terminal of the battery.

9.Slide the battery back into the compartment.

10.Replace the outlet cover and the 6 retaining screws.

11.Recharge the unit for 4 – 8 hours to ensure the UPS performs expected runtime.

REMINDER: Batteries are consider HAZARDOUS WASTE and must be disposed of properly. Contact your local government for more information about proper disposal and recycling of batteries.

DEFINITIONS FOR ILLUMINATED LED INDICATORS

Power	Wiring	Circuit		CONDITION
			Alarm
ON	Fault	Breaker
On	Off	Set	Off	Normal
Off	On/Off	Set	Two	Utility Failure- the UPS is providing power to
				battery power-supplied outlets from its battery.
			Beeps
			Rapid	Utility Failure- The UPS is providing battery
Off	On/Off	Set		power. Rapid beeps indicate the unit will run
			Beeps	out of power shortly.
			Two	System Overload- Occurs when connected
			Beeps	equipment exceeds the rating of unit. Turn the
Off	Off	Up	or	UPS off, unplug at least one piece of equip-
			Rapid	ment, wait 10 seconds, reset the circuit
			Beeps	breaker and turn the unit on.
				Battery Overload- Occurs when connected
				equipment exceeds the rating of battery out-
Off	On/Off	Set	Long	lets of the unit. Turn the UPS off, unplug at
				least one piece of equipment from battery
			Beep
				outlets, wait 10 seconds, reset the circuit
				breaker and turn the unit on.
				Electrical Wiring Fault- This indicates a
				wiring problem with the AC outlet such as
On/Off	On	Set	None	bad ground, miss ground, or reversed wiring.
				User is advised to disconnect all electrical
				equipment from the outlet and have an electri-
				cian check the outlet to insure proper wiring.

7