with no moving parts. Please be aware that they can be overloaded if the output voltage from the source component is too high.
Do not use a source component that has an output level greater than 4 V rms unbalanced, or 8 V rms balanced.
Using a source component with too great an output level will cause distortion.
The input connectors on the In this modern era of diverse source components, it
rear panel are labeled to has become impractical to
match the input selector the actual name of the source. Instead, the
buttons. has simple
Tape Outputs
| By connecting the “Tape Out” jacks on the rear of |
| the |
| recordings may be made directly from the other |
| source components connected to your preamplifier. |
| The tape outputs are switched on and off at the front |
| panel or via the remote. Please refer to the section |
| “Controls and Operation” for further information. |
If a recorder is not installed in | If you are connecting a recorder to your |
your system, the “S2” input | system, be sure to connect its outputs to |
performs exactly like the other | the “S2” input of the |
unbalanced inputs. |
|
| This will prevent the undesired possibility of |
| creating a feedback loop when making a recording. |
4