CyberPower Systems CPS1500AVR user manual Troubleshooting, Specifications

TROUBLESHOOTING

Problem	Possible Cause	Solution
Outlets do not provide	Circuit breaker is tripped due	Turn the UPS off and unplug at least one
power to equipment	to overload	piece of equipment. Wait 10 seconds, reset
		the circuit breaker and then turn the UPS on.
	Batteries are discharged	Allow the unit to recharge for at least 4 hours.
	Unit has been damaged by a	Contact CyberPower Systems at
	surge or spike.	tech@cyberpowersystems.com
The UPS does not	Batteries are not fully charged.	Recharge the battery by leaving the UPS
perform expected runtime.		plugged in.
	Batteries are worn out.	Contact CyberPower Systems at
		tech@cyberpowersystems.com
The UPS will not turn on.	The on/off switch is designed to	Turn the UPS off. W ait 10 seconds and then
	prevent damage by rapidly	turn the UPS on.
	turning it off and on.
	The unit is not connected to an	The unit must be connected to a 110/120v outlet.
	AC outlet.
	The batteries are worn out.	Contact CyberPower Systems at
		tech@cyberpowersystems.com
	Mechanical problem.	Contact CyberPower Systems at
		tech@cyberpowersystems.com
PowerPanel Plus™ is	The serial cable is not connected.	Connect the serial cable to the UPS unit and an
inactive (all icons are gray).		open serial port on the back of the computer.
		You must use the cable that came with the unit.
	The serial cable is connected to	The primary computer must be connected to
	the wrong port.	Port I on the UPS. Check the bac k of the
		computer for a different serial port. Move the
		cable to this port.
	The unit is not providing battery	Turn the UPS off. W ait 10 seconds and then
	power.	turn the UPS on. This should reset the unit.
	The serial cable is not the cable	You must use the cable that came with the unit.
	that was provided with the unit.
SPECIFICATIONS

General

Input

UPS- Output

Battery

Interface

Model	CPS1500AVR
Capacity	1500AV (950W)
Frequency	47Hz - 63Hz
Voltage Range	85v - 150v
Line Conditioning Regulation	AVR Max. boost 15% of input voltage for output regulation
	while input voltage is from 8% to 30% under nominal
	AVR Max. buck 15% of input voltage for output regulation
	while input voltage is from 8% to 26% over nominal
On Battery Output Voltage	120 Vac ÿ±5% (user adjustable)
Transfer Time	4ms typical, including detection time
On Battery Output Wave Form	Simulated Sine Wave Form
Max. Load	1500VA (950W)
Battery Type	Sealed, maintenance-free lead acid battery
Number of Batteries	12v/7AH x 4
Recharge Time	4 to 8 hours from total discharge
Communication	RS-232 with Plug and Play interface
LED Indicators	Power On, Electrical Wiring Fault, AVR, Using Battery,
	Battery Charge Level, Load Level
Ouput Receptacles	6 Battery-powered and full-time surge protection

14