Features
■All outputs skew <100 ps typical (250 max.)
■15 to 80 MHz output operation
■Zero input to output delay
■50% duty cycle outputs
■Outputs drive 50Ω terminated lines
CY7B9910
CY7B9920
Low Skew Clock Buffer
The completely integrated PLL enables “zero delay” capability. External divide capability, combined with the internal PLL, allows distribution of a low frequency clock that is multiplied by virtually any factor at the clock destination. This facility minimizes clock distribution difficulty while allowing maximum system clock speed and flexibility.
Block Diagram Description
Phase Frequency Detector and Filter
■Low operating current
■
■Jitter:<200 ps peak to peak, <25 ps RMS
Functional Description
The CY7B9910 and CY7B9920 Low Skew Clock Buffers offer low skew system clock distribution. These multiple output clock drivers optimize the timing of high performance computer systems. Each of the eight individual drivers can drive terminated transmission lines with impedances as low as 50Ω. They deliver minimal and specified output skews and full swing logic levels (CY7B9910 TTL or CY7B9920 CMOS).
The Phase Frequency Detector and Filter blocks accept inputs from the reference frequency (REF) input and the feedback (FB) input and generate correction information to control the frequency of the Voltage Controlled Oscillator (VCO). These blocks, along with the VCO, form a Phase Locked Loop (PLL) that tracks the incoming REF signal.
VCO
The VCO accepts analog control inputs from the PLL filter block and generates a frequency. The operational range of the VCO is determined by the FS control pin.
Logic Block Diagram
TEST
FB PHASE
FREQ FILTER
REF DET
FS
VOLTAGE
CONTROLLED
OSCILLATOR
Q0
Q1
Q2
Q3
Q4
Q5
Q6
Q7
Cypress Semiconductor Corporation • 198 Champion Court | • | San Jose, CA | • | |
Document Number: |
| Revised August 07, 2007 | ||
[+] Feedback