Cyclades 5000, 2500 quick start To Set up a Private Network, Single Network Setup

AlterPath Manager E2000, 2500, 5000 Quick Start Guide

Figure 7: Single Network Setup

TTo Set up a Private Network

1.Connect an Ethernet cable from the “Eth1” port on the AlterPath Manager to a hub or switch that is connected to your public Ethernet LAN. Refer to the “Private Network Setup” diagram that follows.

2.Connect an Ethernet cable from the “Eth2” port on the AlterPath Manager to a hub or switch that is connected to your private (or managed) Ethernet LAN. Refer to the “Private Network Setup” diagram that follows.

3.Connect the Ethernet ports of any KVM/net, ACS, TS, or OnSite to a hub or switch that is connected to the private Ethernet LAN.

4.Set up the other AlterPath devices in the normal manner. Refer to the documentation for the other AlterPath devices as required.

Figure 8 shows a typical connection setup for a private network. This the most secure setup because the only path to devices on the private LAN is through the APM.

4