Running the First Time Configuration Wizard

3. Running the First Time Configuration Wizard

3)10 Mbps, half duplex

4)100 Mbps, full duplex

5)100 Mbps, half duplex

6)1000 Mbps, full duplex

7)1000 Mbps, half duplex

•Enter the system's hostname (max 30 characters)

•Enter the system's domain name (max 60 chars)

•Enter the primary nameserver's IP address

•Enter the secondary nameserver's IP address

•Enter the NTP server

•Enter the E-mail (SMTP) server

•Enter an authentication method (local, RADIUS, TACACS+, LDAP, Kerberos, NIS, Active Directory)

Note: After you select an authentication service type, you will be prompted with questions that are specific to that type of authentication. For example, if you select RADIUS, you will be prompted for the RADIUS server name and the RADIUS secret.

Once you have finished with the last parameter, the configuration will automatically be saved to flash memory.

If you have made a mistake in any of the foregoing configuration steps, you can usually make adjustments to parameters by running one of the following commands as required:

•setauth

•setdatetime

•setdhcp

•setethernet

•sethosts

•setnames

•setnetwork

•setntp

•setserial

•setsmtp

If you feel you need to configure all the parameters from the beginning, run the defconf command as shown below.