Edimax Technology EW-7811UN manual Federal Communication Commission Interference Statement

Page 3

Federal Communication Commission

Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio technician for help.

FCC Caution

This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.

III

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Page Page Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G Chapter I Product Information ‐2 Safety Information ‐3 System Requirements ‐4 Package Contents ‐5 Familiar with your new wireless network card Chapter II Driver Installation and Configuration ‐1 Network Card Installation Under Windows XP Under Windows Vista and Windows Page Page Page Here ‐2 Connect to Wireless Access Point Page Page Ssid Ascii PAC Page Page Page Page Page ‐3 Connection Profile Management ‐3‐1 Add a new profile Point’s name. This must be identical with EAP Type ‐3‐2 Remove an existing profile ‐3‐3 Edit an existing profile ‐3‐4 Make a copy of existing profile ‐3‐5 Set as default profile ‐4‐1 General Information ‐4‐2 Status ‐4‐3 View Network Statistics Uncheck this box to hide it Page ‐6 Establish secure connection with AP by WPS Page ‐6‐1 PIN Code Page ‐6‐2 Push Button Page Chapter III Soft-AP Function Page Client mode icon Software AP icon To configure software AP, click ‘Config’ button This wireless access point here. Up to If the encryption method is WEP, check either Box as WEP passphrase ‐2 Advanced Settings Page ‐3 Wireless Statistics ‐4 Internet Connection Sharing ICS Chapter IV Appendix ‐2 Troubleshooting Connect is hidden nothing displayed What is the Ieee 802.11g standard? What is Infrastructure? What is WPS?
Top Page Image Contents