Edimax Technology EW-7811UN manual

Page 26

3.A message indicating that you’ve been switched to Windows Zero Configuration mode will appear. Click ‘OK’ to continue.

NOTE: To return to use Edimax utility, uncheck ‘Windows Zero Config’ box.

4.Click ‘Start’ button (should be located at the bottom-left corner of windows desktop), click ‘Control Panel’, then click ‘Network and Internet Connections’ in Control Panel.

20

Image 26

Contents Page Page Federal Communication Commission Interference Statement Page TTE Compliance Statement T a L O G Chapter I Product Information ‐2 Safety Information ‐3 System Requirements ‐4 Package Contents ‐5 Familiar with your new wireless network card Chapter II Driver Installation and Configuration ‐1 Network Card Installation Under Windows XP Under Windows Vista and Windows Page Page Page Here ‐2 Connect to Wireless Access Point Page Page Ssid Ascii PAC Page Page Page Page Page ‐3 Connection Profile Management ‐3‐1 Add a new profile Point’s name. This must be identical with EAP Type ‐3‐2 Remove an existing profile ‐3‐3 Edit an existing profile ‐3‐4 Make a copy of existing profile ‐3‐5 Set as default profile ‐4‐1 General Information ‐4‐2 Status ‐4‐3 View Network Statistics Uncheck this box to hide it Page ‐6 Establish secure connection with AP by WPS Page ‐6‐1 PIN Code Page ‐6‐2 Push Button Page Chapter III Soft-AP Function Page Client mode icon Software AP icon To configure software AP, click ‘Config’ button This wireless access point here. Up to If the encryption method is WEP, check either Box as WEP passphrase ‐2 Advanced Settings Page ‐3 Wireless Statistics ‐4 Internet Connection Sharing ICS Chapter IV Appendix ‐2 Troubleshooting Connect is hidden nothing displayed What is the Ieee 802.11g standard? What is Infrastructure? What is WPS?