Deutsche Telekom 400 quick start Computer HUB/SWITCH

Page 10

This table lists the types of Ethernet cable to use for connecting directly to a computer or to an external hub or switch (if connecting more than four computers).

LAN 10/100M PORT

ETHERNET CABLE TYPE

 

 

 

 

 

 

 

COMPUTER

HUB/SWITCH

 

 

 

1, 2, 3

straight-through

crossover

 

 

 

 

4

UPLINK button ”on“ (pushed in)

straight-through

crossover

 

 

 

 

4

UPLINK button ”off“ (out)

crossover

straight-through

 

 

 

 

The corresponding LAN LED on the front panel lights up when the Teledat Router 400 is on and properly connected to a computer or a hub.

Power inlet 5 Volts DC/2.4A

WARNING! Only use the supplied power adapter.

Connect the round end of the power adapter to the port labeled 5VDC/2.4A on the rear panel of your Teledat Router 400.

Additional Installation Requirements

1.1. A computer with an installed Ethernet NIC (Network Interface Card).

2.2. A DSL modem and an Internet account

10

Image 10
Contents Deutsche Page Preface Never operate the router in humid environments Introduction NAT SUAPackaging List Hardware Installation WAN LED ColorDescription LANPower adapter and cable to wall outlet Computer HUB/SWITCH Turning on Your Teledat Router 400, PC and DSL Modem Setting up Your Windows 95/98/Me Computer Preparing Your NetworkSetting up Your Windows NT/2000/XP Computer Setting up Your Macintosh Computer Checklist Field DescriptionUsing the Web Configurator Page Page Basic Configuration with Wizard Setup Figures 0001 designate the first co-userPage Page Page Page Subject to change Version October