Cambridge Audio Incognito BK10 manual Rear Panel Connections, Speaker output

Page 11

BK10 Table-top keypad

REAR PANEL CONNECTIONS

1 Speaker output

Connect to a pair of speakers with two runs of standard high-quality speaker cable. Speakers of at least 88dB SPL for 1W @ 1 metre efficiency should be used with the BK10. Speakers from 4–8 ohms can be used.

2 Cat5 to BK10

2A Cat-5 cable (terminated with an RJ45 jack plug) is used to connect the

BK10 to an AH10 hub or A-BUS Ready

1receiver.

Incognito table-top keypad 11

Image 11
Contents BK10 Incognito table-top keypad BK10 Table-top keypad ContentsIntroduction Configurations PS5 BUS Ready / Incognito ReadySpeaker cable Full Incognito System BK10 rear Safety precautions Installation NotesSpeaker output Rear Panel ConnectionsStandby/On Keypad ControlsIR window Remote ControlOperating Instructions Volume adjustmentContinuing to hold both buttons will light IR10 Local Source SelectionLocal source selection mode. To enter this mode THD Technical SpecificationsLimited Warranty Incognito BK10