Cambridge Audio Incognito BK10 manual Keypad Controls, Standby/On

Page 12

KEYPAD CONTROLS

34

25

16

8

11

7

9

10

12

1 - 6 The six LEDs indicate the volume level of the BK10. The LEDs also also display the source selected when the source is changed and can also show the status of some other functions. For full instructions on volume adjustment, source selection, sound adjustment and local source selection modes, refer to the ‘Operating instructions’ section of this guide.

7Standby/On

Press to switch the keypad between On and Standby mode. By pressing and holding the Standby button for about 2 seconds, all BK10s connected to the AH10 hub will be turned off. If the BK10 is connected to a Cambridge Audio Incognito Ready Amplifier rather than an AH10 hub, the amplifier will be turned off.

8Volume up

Press to increase the volume or other sound adjustment.

9Source select (right)

Use this key to select the current active source.

12Incognito table-top keypad

Image 12
Contents BK10 Incognito table-top keypad Contents BK10 Table-top keypadIntroduction Configurations BUS Ready / Incognito Ready PS5Speaker cable Full Incognito System BK10 rear Installation Notes Safety precautionsRear Panel Connections Speaker outputKeypad Controls Standby/OnRemote Control IR windowVolume adjustment Operating InstructionsContinuing to hold both buttons will light Local Source Selection IR10Local source selection mode. To enter this mode Technical Specifications THDLimited Warranty Incognito BK10