Fortinet 5003A manual Switch fabric-channel physical-port

config FortiSwitch-5003A CLI reference

switch fabric-channel physical-port

Use this command to change the administrative status of FortiSwitch-5003A fabric channel interfaces (bring each interface up or down) and configure each fabric channel interface to receive heartbeat packets from FortiGate-5001A or 5005FA2 fabric channel interfaces.

Syntax

config switch fabric-channel physical-port edit <interface_name>

set native-vlan <id_number> set allowed-vlans <id_numbers> set stp-state {disable enable}

end

Variables	Description	Default
edit <interface_name>	Enter the name of the FortiSwitch-5003A fabric channel
	interface to configure. You cannot configure physical port
	settings for a trunk. You can configure physical port settings for
	interfaces that have been added to a trunk.
	For the fabric channel <interface_name> can be:
	• slot-2/1used to connect the fabric channels of two
	FortiSwitch-5003A boards installed in the same chassis.
	• slot-3FortiGate chassis slot 3.
	• slot-4FortiGate chassis slot 4.
	• slot-5FortiGate chassis slot 5.
	• slot-6FortiGate-5140 chassis slot 6.
	• slot-7FortiGate-5140 chassis slot 7.
	• slot-8FortiGate-5140 chassis slot 8.
	• slot-9FortiGate-5140 chassis slot 9.
	• slot-10FortiGate-5140 chassis slot 10.
	• slot-11FortiGate-5140 chassis slot 11.
	• slot-12FortiGate-5140 chassis slot 12.
	• slot-13FortiGate-5140 chassis slot 13.
	• slot-14/f8FortiGate-5140 chassis slot 14 or
	FortiSwitch-5003A front panel slot 14/F8.
	• f7 FortiSwitch-5003A front panel slot F7.
	• f6 FortiSwitch-5003A front panel slot F6.
	• f5 FortiSwitch-5003A front panel slot F5.
	• f4 FortiSwitch-5003A front panel slot F4.
	• f3 FortiSwitch-5003A front panel slot F3.
	• f2 FortiSwitch-5003A front panel slot F2.
	• f1 FortiSwitch-5003A front panel slot F1.
heartbeat {disable	Enable or disable listening for heartbeat packets from	disable
enable}	FortiGate-5001A or 5005FA2 fabric interfaces.
	If you enable listening for heartbeat packets on interfaces
	added to link aggregation trunks the FortiSwitch-5003A board
	can detect if a FortiGate-5001A or 5005FA2 board is no longer
	available. You must configure the FortiGate-5001A or 5005FA2
	board to send heartbeat packets using the following
	FortiGate-5001A or 5005FA2 CLI command:
	config system global
	set fortiswitch-heartbeat enable
	end
status {down up}	Bring the interface up or down.	up

	FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
96	01-30000-85717-20081205