Cambridge Audio Incognito BK10 manual BK10 rear

BK10 Table-top keypad

Note: When using a BK10 keypad with an AH10 hub, an Incognito PS10 power supply unit MUST be used.

Please consult the AH10 Incognito Multi-Room Installation Guide for full details of the various options available for the full Incognito system.

IMPORTANT! The BK10 is default set to the A-BUS Ready/Incognito Ready configuration. For use in a full Incognito system, the mode switch (located inside the keypad block) must be set to the alternative “AH10” mode.

Use a screw driver to carefully remove the backplate and set the mode switch to the "AH10" position as shown below:

BK10 rear

Note: Setting the mode switch to the wrong setting can cause erroneous operation!

Incognito table-top keypad 9