Furuno MU-155C manual Remote Controller Setting, System menu

3.4 Remote Controller Setting

A remote controller can be set to be operative with a specific display unit, in the case of multiple MU-155C display units. Set the remote controller mode desired on the SYSTEM menu as follows;

1.Press the [MENU] key to show the main menu.

2.Press the [►] key to select SYSTEM.

						Remote controller ID square
Display
unit ID	RGB1	RGB2	DVI	VIDEO1	VIDEO2	VIDEO3	OSD	SYSTEM
	INFRARED REMOTE			A
	DEFAULT RESET			NO
	INFORMATION			fH: 80KHz	fV: 75Hz
	RGB1	: 1280x1024
	RGB2	: 640x480		fH: 31KHz	fV: 60Hz
	DVI	: NO SIGNAL
	VIDEO1: NTSC
	VIDEO2: PAL
	VIDEO3: NO SIGNAL
	PROGRAM NO. *****

SYSTEM menu

3.Select INFRARED REMOTE.

4.Point the remote controller toward the display unit, and press any key on the remote controller. The current setting of remote controller is shown inside the remote controller setting square.

5.Press the [RGB2] and [BRILL +] keys together on the remote controller to change the remote controller ID among A, B, C and D.

Your selection appears inside the square.

6.Press the [◄] or [►] key so that the display unit ID is the same as the remote controller ID in the square.

7.Press the [MENU] key to close the menu.

12