Carrier Access KTA Installation and Setting, LED Indicators, Application figure, Small PABX

Page 4

2.2 LED Indicators

2.2 LED Indicators

Power TX

RX Service Phone MSG

Power——Power On LED

TX——Network data being transmitted RX——Network data being received

Service——Service connected (Remains illuminated when successfully logged-on to server)

Phone——phone in operation (phone in-used when light on means working under VoIP, when light off means working under PSTN)

MSG——unanswered call LED (unanswered call appeared if light on)

2.3 Application figure

Internet

ISP

Telecom

PC

LAN

PHONE LINE

Small PABX

1	2	3	1	2	3	1	2	3
4	5	6	4	5	6	4	5	6
7	8	9	7	8	9	7	8	9
*	8	#	*	8	#	*	8	#

Instruction:KTA 1000,KTA1001 without LINE port,KTA1001,KTA1011 without PC port

3. Installation and Setting

3.1 Installation

(1)Locate your KTA close to your Internet connection and a power outlet.

(2)Plug the RJ-45 connector of the Ethernet 10/100Base-T cable into the KTA’s side input port ④, and plug the

other side into a hub or switch, or wall/ground socket of the structuring cable.

4

Image 4

Contents Adapter KTA Series User Manual 3.2.1 Configuring Network Parameters from Telephone Handset 2. Sketch 1. Introduction2.1 Ports figure 3. Installation and Setting 2.2 LED Indicators3.1 Installation 2.3 Application figure3.2.1 Configuring Network Parameters from Telephone Handset 3.2 Configuration3.2.2 Configuring Network Parameters from Web Browser Fill in IP Fill in DNS Audio codec Ringtype 4.1 Making and Receiving calls 4. FunctionsNotice It is applicable to all KTA users 4.2 Use digitmap 4.3 Call Forwarding4.1.2 Receiving b Notice it is only for the users except from a5. Technical Parameter 5.1 The electronic specifications5.2 Working/storing environment 6. Frequent Problems and Solutions 5.3 Dimensions7.1 Features 7. Appendix7.2 Standards and agreements 7.4 Commands For Setting Network Parameters7.3 Recommend usage net condition