Carrier Access KTA user manual Fill in IP

Page 6
Fill in IP

After network connection, please pick up handset, press key “#*047#” to hear IP address of the adaptor box. In the address field of browser, type the IP address and press ENTER to display the Settings page. A log-in page will be shown. Enter log-in password to set parameters. The default password is 1234.

If adaptor box cannot get IP, enter “##3427# to cancel DHCP mode. After reset and beep sound heard, please pick up the handset, enter “#73847#xxx*xxx*xxx*xxx#” to set IP address of adaptor box. Get the IP address and use browser to set up.

¾Network Settings

Depending on the requirement of your ISP or Network you can configure the KTA with a Static IP, DHCP, or PPPoE:

Static IP: If your ISP / Network requires the use of a Static IP then you will be required to complete all of the parameters listed below:

Fill in IP

Fill in subnet mask

Fill in default

 

 

gateway ip

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Adapter KTA Series User Manual 3.2.1 Configuring Network Parameters from Telephone Handset 1. Introduction 2. Sketch 2.1 Ports figure 3.1 Installation 3. Installation and Setting2.2 LED Indicators 2.3 Application figure3.2 Configuration 3.2.1 Configuring Network Parameters from Telephone Handset3.2.2 Configuring Network Parameters from Web Browser Fill in IP Fill in DNS Audio codec Ringtype 4. Functions 4.1 Making and Receiving callsNotice It is applicable to all KTA users 4.1.2 Receiving 4.2 Use digitmap4.3 Call Forwarding b Notice it is only for the users except from a5.1 The electronic specifications 5. Technical Parameter5.2 Working/storing environment 7.1 Features 6. Frequent Problems and Solutions5.3 Dimensions 7. Appendix7.4 Commands For Setting Network Parameters 7.2 Standards and agreements7.3 Recommend usage net condition
Top Page Image Contents