Juniper Networks Gigabit Ethernet IQ PIC with SFP, See the M20 Internet Router Hardware Guide

Gigabit Ethernet IQ PIC with SFP

Gigabit Ethernet IQ PIC with SFP

Software release ■ JUNOS 6.0 and later

Description	■	One Gigabit Ethernet port
	■ Power requirement: 0.46 A @ 48 V (22 W)
	■ Intelligent queuing (IQ) PICs support fine-grained queuing per-logical interface.
Hardware features	■	High-performance throughput at speeds up to 1 Gbps
	■ Full-duplex mode
	■ Large MTUs of up to 9192 bytes
Software features	■	Optical diagnostics and related alarms (JUNOS Release 8.2 and later)
	■ Quality of service (QoS) per channel: Weighted round-robin (WRR), Random early drop
		(RED), Weighted random early drop (WRED)
	■ Virtual Router Redundancy Protocol (VRRP) support
	■	802.1Q Virtual LANs
	■ VLAN stacking and rewriting
	■ MAC policing, accounting, and filters
	■ JUNOS Release 7.0 or later is required to configure graceful Routing Engine switchover
		(GRES).
Cables and connectors	■	The Gigabit Ethernet IQ PICs use small form factor-pluggables (SFPs) that allow different
		interfaces to be used on the PIC. For information about installing and removing SFPs,
		see the M20 Internet Router Hardware Guide.
	■ SX, LX, and LH SFPs:
		■ Duplex LC/PC connector (RX and TX)
		■ Optical interface support—See Table 13 on page 52
	■	1000Base-T SFPs:
		■ Connector: Four-pair, Category 5 shielded twisted pair connectivity through an RJ-45
		connector

■ Pinout: MDI crossover

■ Length: 328 ft/100 m

Gigabit Ethernet IQ PIC with SFP ■ 51