B&B Electronics HVD100A3 manual Function code 10 hex stop receive

Page 17

Byte	Byte value	Byte Function
number	(hex)
1	01	Start of frame
2	02	The number of control bytes
3	01	ID byte 01= J1708
4	10	Function code 10 hex stop receive
5	00	Number of data bytes (00 place holder)
6	14	Checksum (bytes 1 through 5 added
		together)

After sending this command to the device, the device will respond with a confirmation message and data will cease. Note that there is the possibility of an incomplete message being sent to the PC after sending this command. Use the check-sum to verify all messages.

To restart reception, send the (01, 02, 01, 11, 00, 15) command to the HDV.

HDV100A3 Command & Response Manual-1306cr

13

B&B Electronics -- 707 Dayton Rd. -- PO Box 1040 -- Ottawa, IL 61350

PH (815) 433-5100 -- FAX (815) 433-5104

Image 17

Contents HDV100A3 Command Response Protocol Page Table of Contents Do Not Transmit Any Messages to the network Introduction Intelligent Mode VerificationIntelligent Mode Message Structure Intelligent Mode Command ProtocolSOF Control Field StructureFormatting the Control Bytes Detailed Description of General Function Codes Command AcknowledgementRS-232 Baud Rate Setup HDV100A3 Command & Response Manual-1306cr Setting Baud 1, Baud Baud Rate Setup Table UB3 Baud Rate ExampleByte Byte Function Number Value Hex Reply from HDV100A3 Byte Function Number ValueFunction code 20 = stop time stamping Vendor Information Master Reset CommandByte Byte Value Byte Function Number Hex J1708 CommandsReceiving Data from the J1708 Bus Function code 10 hex stop receive Priority Byte Value Binary Value Hex Value Transmitting Data to the J1708 BusID bytes 9 = transmit OK Set Filter Off Byte Function Number Value J1708 Message FilterSet Filter Active Byte Function Number Value Data Broadcast MessageByte 6 Priority Values Byte 4 ValuesJ1939 Commands Stop Receive on J1939 Bus Start Receive on J1939 BusArbitration Field Y1, Y2, Y3, Y4 Message received from the HDV will be formatted as follows MSB-1 Transmit Data to J1939 BusMSB-2 Set MaskSet Filter 1 to HDV100A3 Command & Response Manual-1306cr J1939 Header Worksheet DEC HEX Error Codes