B&B Electronics EIR510-2SC-T manual „ Security, 802.1X/Radius Configuration, System Configuration

Page 95

[NOTE]

1.When X-Ring function is enabled, disable the RSTP function. X-Ring and RSTP cannot exist at the same time.

2.If the configuration is not saved, it will be lost when the switch is powered down.

„Security

In this section, you can configure 802.1x and MAC address table.

802.1X/Radius Configuration

802.1x is an IEEE authentication specification that allows a client to connect to a wireless access point or wired switch but prevents the client from gaining access to the Internet until it proves authority by providing a user name and password, which is verified by a separate server.

System Configuration

1.IEEE 802.1x Protocol: Enable or disable 802.1x protocol.

2.Radius Server IP: Enter the Radius Server IP address.

3.Server Port: Enter the UDP destination port for authentication requests to the Radius Server.

4.Accounting Port: Enter the UDP destination port for accounting requests to the Radius Server.

5.Shared Key: Enter an encryption key for use during authentication sessions. This key must match the encryption key used on the Radius Server.

6.NAS, Identifier: Enter the identifier of the radius client.

7.Click Apply .

Manual Documentation Number: EIR510-xSFP-T_0708m

87

B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104www.bb-elec.com

B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445www.bb-europe.com

Image 95
Contents Product Description Ten Port Managed Industrial Ethernet Switches FCC Content About Web-based Management Preparing for Web Management Tftp Restore Configuration Tftp Backup Configuration Rapid Spanning Tree Technical Specification Introduction FeaturesManual Documentation Number EIR510-xSFP-T0708m Package Contents Front Panel Physical Dimension W x D x HBottom View P1 through P8 LED IndicatorsFault Status MeaningRJ-45 Pin Assignments Pin Number Ports„ RJ-45 ports „ Fiber Port Cabling Wiring the Power Inputs 1A@24V Wiring the Fault Alarm ContactDIN-Rail Mounting Mounting InstallationManual Documentation Number EIR510-xSFP-T0708m Panel Mounting Installation Steps Hardware InstallationRing Application Network ApplicationCoupling Ring Application Dual Homing Application DB9 Connector RJ-45 Connector Connecting to the Console PortLogin in the Console Interface CLI Management Modes Access Prompt Exit About This Mode1 Method Commands LevelVlan Commands Set ListSystem Commands Set High IP PasswordUsername Low IP101001000auto Port Commands SetPortid Full halfValue Enable Disable Trunk Commands Set GroupID Vlan Commands SetTaggedVID List Trunk-link tagSeconds Spanning Tree Commands Set~61440 Stp-path-cost Spanning-treeHello-time seconds Forward-time secondsTrueFalse QOS Commands SetWeighted-fairstrict AutoTrueFalseOnlycos-firsttos-first Igmp Commands SetPort-basedcos-onlytos Snmp Commands Set Mac / Filter Table Commands SetCommunity-string Authentication Password PrivacyV1v2cv3v1v2cv3 CommunityExcludedIncluded ExactPrifixRead View Name Write View Name Notify View View Name802.1x Commands Set Port Mirroring Commands SetSec Port IDWords Authorize Disable reject acceptNumber Clientserverboth Tftp Commands SetSystemLog, Smtp and Event Commands Set Link-UPLink-DownBot AccountIndex Email address SystemlogSMTPBothMinute Sntp Commands SetStart time End time Ring Commands Set No Xring dualhoming No XringNo Xring master No Xring coupleringPreparing for Web Management About Web-based ManagementSystem Login System Information IP ConfigurationDhcp Server System configuration Dhcp Server Port and IP Bindings Dhcp Client System ConfigurationTftp Update Firmware Tftp Server IP Address Enter the Tftp server IP Tftp Restore ConfigurationTftp Backup Configuration System Event Log Syslog Configuration System Event Log Smtp Configuration System Event Log Event Configuration Fault Relay Alarm Local Time Zone Conversion from UTC Time at 1200 UTC Sntp ConfigurationManual Documentation Number EIR510-xSFP-T0708m „ Daylight Saving Offset mins Enter the offset in minutes IP Security Port Statistics User AuthenticationPort Control Port Trunk Aggregator settingRemove State Activity Aggregator InformationPort Mirroring Rate Limiting Vlan configuration Vlan configuration Port-based Vlan „ The Vlan is displayed Use 802.1Q Vlan 802.1Q Configuration„ Hybrid Link Both Access Link and Trunk Link Group ConfigurationRapid Spanning Tree Rstp System ConfigurationRstp System Configuration interface Rstp Port Configuration „ Community Strings Snmp ConfigurationSystem Configuration Trap Configuration User Profile SNMPV3 Configuration„ Authentication Password Enter the password Context TableSnmp V3 configuration interface MIBview Table Access TableGroup Table QoS Policy and Priority Type QoS ConfigurationQoS Configuration interface Port Base Priority COS ConfigurationTOS Configuration Report Igmp ConfigurationMessage Description QueryRing Ring Interface „ Security 802.1X/Radius ConfigurationSystem Configuration 802.1x Per Port Configuration Misc Configuration „ Add the Static MAC Address MAC Address TableStatic MAC Address MAC Filtering All MAC Addresses Factory DefaultSystem Reboot Save ConfigurationTrouble shooting RFC Standard StandardProtocol ManagementPacket filter Snmp TrapTechnology Transfer RateClass of service „ SC Single mode 9/125um Optical cablePower Supply PowerSecurity Firmware updateRelay Alarm Management IPSafety InstallTemperature Case Dimensions