Avaya manual Hunt Groups in the Cajun P550/P880 Manager, Creating a Hunt Group

Configuring the Cajun Switch Using the P550/P880 Manager

■All ports in a hunt group must be the same speed.

■Packets arriving on different fabric ports within the switch have more evenly balanced loads.

■Hunt groups do not load share if the source and destination traffic and the hunt group ports are on the same fabric port. Most I/O modules divide their ports evenly across two fabric ports. For 10-port and 12-port I/O modules, all ports use a single fabric port.

■The first port assigned to a hunt group becomes the flood port. It can not be changed unless the flood port is disabled.

Hunt Groups in the Cajun P550/P880 Manager

Using the Cajun P550/P880 Manager, you can launch the Hunt Group Configuration dialog box of the Cajun Switch Web Agent. In this dialog box, you can complete any of the following tasks:

■Creating a Hunt Group

■Viewing Hunt Group Members

■Adding a Port to a Hunt Group

■Deleting a Hunt Group

■Redistributing Hunt Group Learned Addresses

For information about the Hunt Group Configuration dialog box and associated tasks, refer to “Using VLANs, Spanning Tree, and Hunt Groups (Layer 2 and Layer 3)” in the Cajun P550/P220 Switch Operations Guide.

Creating a Hunt Group

To create a hunt group:

1.Start Cajun P550/P880 Manager. For information about starting the Cajun P550/P880 Manager, refer to "Starting the Cajun P550/P880 Manager" earlier in this chapter.

2.Select Tools > Link Aggregation.

Or

From the tool bar, click Link Aggregation.

Cajun P550/P880 Manager User Guide 2-15