Configuring the Cajun Switch Using the P550/P880 Manager
| Table |
|
|
Parameter | Definition |
|
|
Flow | Determines if IEEE 802.3z pause control is used on this |
Control | port. The pause mechanism allows the port to stop a |
Mode | sending station from sending more packets if the |
| receiving port’s buffers are full. This helps prevent lost |
| or dropped packets. |
| This feature is recommended for use primarily on end |
| station connections. Using this feature on trunk ports |
| can cause unnecessary congestion on the network. |
|
|
Remote | Proprietary mechanism to detect remote link errors on |
Fault | Cajun gigabit ports. The default value is Disabled. |
Detect | The remote fault detection functionality should be |
| |
| enabled (on both ends of a Cajun to Cajun link) in two |
| cases: |
| • When two Cajun gigabit ports are connected that |
| do not support |
| • When a Cajun gigabit port that does not support |
| |
| port that does support |
|
|
PACE | PACE™ Priority Mode determines if the port |
Priority | detects 3Com’s proprietary PACE format as |
Mode | packets pass through the port. PACE enables a |
| packet’s priority to be set at the adapter. Higher |
| priority packets move through the switch before |
| lower packets. PACE Priority Mode is enabled by |
| default. To disable PACE Priority Mode, select |
| Disable from the PACE Priority Mode |
| menu. |
|
|
3.In the Name field, enter a port name.
4.To configure an
Or
To configure a trunk port, select Service Port.
Cajun P550/P880 Manager User Guide |