Conclusion | Avaya 2520-24-POE specs

∙Connect the Avaya PD to a PoE enabled port on the ProCurve 2520-24-PoE Switch and verify that the PD powers on successfully. If the PD does not power on, enter the command show power-over-ethernet <portlist> where <portlist> is the name of the port on the ProCurve 2520-24-PoE Switch.

Status and Counters - Port Power Status for port 1

Power Enable	: Yes
		LLDP Detect	: disabled
Priority	: low	Configured Type	:
AllocateBy	: usage	Value	: 17 W
Detection Status	: Delivering	Power Class	: 2
Over Current Cnt	: 0	MPS Absent Cnt	: 0
Power Denied Cnt	: 0	Short Cnt	: 0
Voltage	: 49.4 V	Current	: 96 mA
Power	: 4.7 W

∙Verify that Avaya 1600/5600/9600 Series IP Telephones have successfully registered to either Avaya AuraTM Communication Manager or Avaya IP Offce

oFor the Avaya 1600/9600 Series IP Telephones check Avaya AuraTM Communication Manager

oFor the Avaya 5600 Series IP Telephones check Avaya IP Office.

8.Conclusion

These Application Notes describe the steps for configuring the HP ProCurve 2520-24-PoE Switch to provide inline PoE to Avaya IP telephones. It was verified that PoE was delivered successfully to all Avaya PD’s tested.

TMA; Reviewed:	Solution & Interoperability Test Lab Application Notes	8 of 10
SPOC 11/16/2009	©2009 Avaya Inc. All Rights Reserved.	ProC2520-24PoE