Bay Technical Associates U140E116-02 owner manual

Page 25

pliers from side to side, so as not to bend chip pins. Pull loosened EPROM all the way out.

4.Install the new EPROM into socket U2. The EPROM is notched; the notch on the EPROM should line up with the notch on the socket. Be careful not to bend any of the pins. Make sure none of the pins miss their sockets. If the socket has more holes than chip pins, the pins should line up starting at the edge of the board.

5.Re-install the V93A and apply power to the unit. The upgrade is now complete. Before you begin operations, check the configuration status to make certain it matches your application. See Section 5 for complete instructions.

25

Image 25
Contents BayTech Manual Publication #U140E116-02 Page Phone 800-523-2702 or Table of Contents Page General Information Compression V.42bis, MNP5 SpecificationsCables & Adapters Software Utility DisketteEIA-232 Connection PC, PS/2 Computer/Terminal Adapter BayTech Part No FRJ45PC-3 RJ-45 Cable BayTech Part No. RJ08X010 10 feet Modem Connection Login PasswordOperation Port Selection Menu Manual Mode Exit Logout Unit ResetConfiguration Status Serial Port ConfigurationSave Changes Permanently ? Y/N Port Device Name Port Select Code Disconnect Time Guard Local Modem Setup Ring Detect Reset Echo ModeModem LED Indicators LED V93A Eprom UpgradePage V93A Mechanical Layout Procomm Plusr README.RDM Index