Optimus STAV-3370 owner manual Installing Remote Control’s Batteries

Preparing Your Receiver

Using One Remote Control for More than One Unit

Note: When you plug the cable into a component’s CONTROL IN jack, that component’s remote sensor does not function.

	CONTROL
IN	IN
OUT	OUT
CONTROL

If you also have an Optimus professional series CD player, VCR, or cassette deck with the OSR mark, you can connect its CONTROL IN jack to the receiver so you can control all of your equipment with a single remote control. You can also use the other component’s remote control by pointing it at the receiver’s front panel.

1.Connect each component to the receiver as shown in “Connecting Pro- gram Sources.”

2.Connect the cable supplied with the CD player, VCR, or cassette deck between the receiver’s CONTROL OUT jack and the other component’s

CONTROL IN jack.

3.When you want to control more than one other component using the receiver’s remote control, daisy-chain the CONTROL OUT and CONTROL IN connections as shown.

Receiver	Other Component
	with OSR Mark

To the CONTROL IN jack of Another Component Having the OSR mark

Remote

Control

Installing the

Remote Control’s Batteries

Cautions:

•Use only fresh batteries of the recom- mended size and type.

•Always remove old or weak batteries. Batteries can leak chemicals that can damage electronic circuits.

The remote control uses two AA batteries (not included). For the longest battery life, we recommend Radio Shack’s alkaline batteries (Cat. No. 23-557).

1.Press and open the battery compartment cover.

2. Place two fresh AA batteries in the compartment as indicated by the polarity symbols (+ and –) marked in the compartment.

Note: If the remote’s range is reduced, replace the batteries immediately.

3.Replace the battery compartment cover.

12