Uplink Connections
7Turn your power source(s) on. The PWR (power) LED on both the interface module and management module faceplates will illuminate solid green to indicate the modules are receiving power.
|
| Power LED |
|
|
|
MULTIPLEXER UPLINK MODULE | FAN PWR | Lnk Act Dplx | ADSL2+ INVERSE MULTIPLEXER | PWR | RX TX LK 1 2 |
Management |
| Interface | |||
|
| ||||
| Module |
| Module |
|
Uplink Connections
No configuration is necessary for Uplink Interface Modules (UIMs) or Media Interface Modules (MIMs) installed on the management module in your 4000E to operate at default settings. However, if you wish to run your uplink connections at settings other than the UIM or MIM defaults, configure the UIM or MIM prior to making a connection.
For further connection and configuration information, refer to the installation instructions of your particular UIM or MIM model.
Uplink Module
MULTIPLEXER UPLINK MODULE FAN PWR | Lnk | Act | Dplx |
ADSL2+ INVERSE MULTIPLEXER | PWR | RX TX LK | 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 |
MUM |
| 4000E |
|
| IP |
|
| DSL Access Multiplexer |
| U1 |
|
| 4 |
|
| 3 | A |
|
| C |
|
| C |
|
| E |
|
| S |
| 2 | S |
TIM | 1 |
|
Subscriber Lines
No configuration is necessary for the interface module(s) installed in your 4000E to operate at default settings. However, if you wish to run your subscriber connections at settings other than the factory defaults, configure the interface module(s) prior to connection. Refer to the installation instructions for your particular interface module(s).
The 4000E chassis supports ADSL, IDSL, SDSL and T1/E1 technologies. Ensure that the subscriber lines you are connecting correspond with the technology of the interface module(s) installed in your 4000E.
4000E IP Broadband Loop Carrier Installation Instructions | 13 |