Zhone Technologies 4000E installation instructions Subscriber Lines

Page 15

Subscriber Lines

4Pull the hook-and-loop fastener strap upward, making sure that it is snug against the connector, then pull the strap back down, such that the hook-and-loop fastener layers stick to one another across the top of the connector.

05-17842

5Tuck the tab at the end of the strap down between the connector frames so that it is out of the way of other connections.

05-17843

6Screw the right side of the RJ21 cable connector into the jack screw on the right side of the RJ21 connector frame on the chassis. Note: If you are using a 120 or 180 degree cable, both the right and left sides of the cable connector should be screwed to the RJ21 connector frame on the chassis.

05-17844

IPD4-A2-ZZ40-20

4000E IP Broadband Loop Carrier Installation Instructions

15

Image 15

Contents Contents End User License Agreement Zhone and Affiliates End User License Agreement Zhone and Affiliates Introduction Unpacking and Inspecting the Equipment Handling Precautions for STATIC-SENSITIVE DevicesInstallation on a Tabletop Installation OptionsInstallation in a Rack Installing a Management Module Installing Your Management ModuleInstalling Your Interface Modules Installing Your Interface ModulesDo not operate the 4000E without a ground connection Powering Up Your 4000E BLCPowering Up Your 4000E BLC 48V Subscriber Lines Uplink ConnectionsInterface Module a Interface Module B Connectors Subscriber Lines Configuration and Management Securing the Connecting CablesFan Module Fan ModuleEMC SpecificationsImportant Safety Instructions United States EMI NoticesCanada CE Marking Product Documentation OnlineContacting Global Service and Support Service RequirementsTechnical Support