Optimus PRO-SW100P manual Connecting to Line Out Terminals

HIGH LEVEL OUTPUT

40-4080.fm Page 4 Wednesday, August 11, 1999 10:58 AM

Caution: To avoid any damage to the subwoofer or amplifier, disconnect power from your components before making any connections.

Connecting to Line Out Terminals

Your amplifier/receiver’s line out jacks might be labeled either REC OUT or

PRE OUT.

Right	Amplifier/Receiver		Left
Speaker	Output Terminal		Speaker
	HIGH LEVEL INPUT	Rec Out
	HIGH LEVEL OUTPUT
	+ R – – L +	L
		R
+ –			+ –

	HIGH LEVEL INPUT
+	R	-	+	L	-
					LOW LEVEL		PHASE
					INPUT			FREQUENCY
						VOLUME
POWER					L		REV	NORM	HZ
						CONTROL			80
STANDBY								60	100
RED					R				150
+	R	-	+	L	-			50	200

HIGH LEVEL OUTPUT MIN MAX

Connecting to Speaker Terminals

Connect the amplifier/receiver’s speaker output terminals to the PRO- SW100P’s HIGH LEVEL INPUT speaker terminals. Be sure to connect the ter- minals in phase, connecting positive

(+)to positive and negative (–) to neg- ative. Wiring the PRO-SW100P with + to – greatly reduces bass perfor- mance.

Right	Amplifier/Receiver	Left
Speaker	Output Terminal	Speaker

HIGH LEVEL OUT PUT

1.Connect the PRO-SW100P’s LOW LEVEL INPUT jacks to the ampli- fier/receiver’s line out jacks (or TV’s audio line out jacks) using phono cables (not supplied). Be sure to connect the jacks in phase (left to left and right to right).

2.Connect your satellite speakers (if any) to the amplifier’s or receiver’s output terminals as they would normally be connected.

Note: If you connect your PRO- SW100P to your amplifier/receiver’s line out terminals and your amplifier or receiver has a line out selector switch, be sure to switch it to the correct source.

4

Connecting Speakers

You can connect your left and right speakers to your amplifier/receiver (as shown on Page 4), or to the PRO- SW100P’s

speaker terminals (as shown above).

If you use MEGACABLEâ, or any oth- er high quality, low gauge speaker wire, the terminals will be too small to accommodate the wires. You need two pairs of Speaker Pins (RadioShack Unlimited Cat. No. 10458503) to make the connection. Follow these steps to connect the wires to each terminal us- ing Speaker Pins.