Asante Technologies FH100TX16, FH100TX8 Mounting the FriendlyNet Hub, Equipment Rack Placement

Turn the hub over so that the bottom of the chassis faces up.

Peel the protective backing off of each rubber foot.

Installation

Mounting the FriendlyNet Hub

The FriendlyNet Fast Ethernet Hub can be mounted in a standard 19-inch equipment rack or it can be prepared for desktop placement. This section describes both mounting scenarios.

Equipment Rack Placement

To mount the hub in an equipment rack:

1 Mount one rack-mounting bracket (provided) on each side of the hub using the six screws provided. See Figure 2-5.

Figure 2-5 Installing rack-mounting brackets

2 Place the hub in the equipment rack.

3 Use equipment rack screws (not provided) to secure the hub by its brackets to the equipment rack.

Desktop Placement

If your site does not have an equipment rack, the hub can be placed on a desk- top after applying the four rubber feet included in your package.

To install the hub’s rubber feet:

1

2

3 Position each rubber foot over the recessed areas near the four corners of the hub.

4

5

Press each rubber foot into place.

Place the hub on a horizontal surface.

Page 2-6