Asante Technologies 10NIC-PCITM manual Microsoft Windows

Installing Network Drivers

10 Press Enter to exit to the DOS prompt.

11 Restart the computer to load the network drivers.

12 To log in to the network, type:

F:login

Microsoft Windows 95

This section explains how to install the driver to use your Asanté 10NIC-PCI adapter with Windows 95.

ΔNote:If you are installing Windows 95 for the first time, the Plug and Play technology of Windows 95 will automatically detect the Asanté 10NIC-PCI adapter.

It will select, and ask to install, the generic “PCI Ethernet DEC- chip 21041 Based Adapter” driver from the Windows 95 soft- ware.Although this driver will work with the Asanté 10NIC-PCI adapter, Asanté recommends you instead install the Asanté driver.

The following instructions assume you have just installed the 10NIC-PCI adapter in a PC already equipped with Windows 95:

1	Start the computer.
	During startup,Windows 95 will detect any new card in the
	PCI bus and present a dialog box titled New Hardware Found. It
	will state the 10NIC-PCI is a “PCI Ethernet DECchip 21041
	Based Adapter”.
	After a few seconds, you will then see a Networkdialog box
	stating that “You must provide computer and workgroup
	names that will identify the computer on the network” (this
	dialog will only appear if you have never previously con-
	nected this computer to a network).
2	Click OKto dismiss this dialog box.
	A different dialog box, again called Network, appears with

three tabs labeled Configuration, Identification, and Access Control.

Page 3-10