Troubleshooting
PC Diagnostic Program
To run the diagnostic program on your PC, follow the procedure below.
1
2
3
Insert the Asanté Driver Disk into drive A.
At the DOS prompt, type the following command:
A:\UTILITY\DIAGPCI
Press Enter.
A warning message window appears that you should read.
4 Press C to continue (or ESC to abort the diagnostic pro- gram).
The diagnostic program searches for adapters installed in your computer system.A screen appears showing you the adapters found.
5 Select the appropriate adapter from the list and press Enter.
Use the UP or DOWN arrow key to make a selection.
A screen appears showing you the following menu options:
❏Loopback Tests— tests the adapter by sending packets across the components for loopback tests.
❏Adapter Status— displays the adapter configuration information such as PCI slot number, base I/O address, interrupt line, media type, network speed, and Ethernet node address.
❏Go Back to previous screen
6 Select Loopback Testsand press Enter.
The program runs a series of tests.Their results are dis- played for you after each test with a PASSED or FAILED indi- cation.
7 When the tests finish, verify the results to make sure that all tests passed.
If a test fails, check that the adapter is seated properly in a PCI
8 Press any key to return to the menu option screen.
Page