American Audio DIGI-PRO specs

GENERAL FUNCTIONS AND CONTROLS - PLAYER UNIT

41.DRIVE 2 REMOTE JACK - Connect the supplied 8 pin din cable from this jack to the remote control's channel 2 remote connector. This will allow you to control the player functions with the remote unit.

42.DRIVE 2 DIGITAL OUT - This jack sends a digital stereo out signal. Use this connection to create near perfect copies of your disc to a Mini disc, CD-R, or any other recording device with a digital input.

43.DRIVE 2 AUDIO OUT R & L - These jacks send a left and right analog mono output signal. Use these jacks to send standard audio to a mixer or receiver. The red colored jack represents the right channel output and white jack represents the left channels output.

44.VOLTAGE SELECTOR - Because power supplies vary from location to location a voltage selector switch has been incorporated in the unit's design. This switch can select a voltage input of 120v or 220v to accommodate the two major power source. Always be sure to disconnect the power plug before changing the voltage.

45.POWER CONNECTOR - This is the main power connection. Only use the supplied polar- ized power cord. Use of any other power may

result in sever damage to the unit. Be sure the local power matches the unit’s required power.

46.SCRATCH BOX INPUT (Drive 1)- This jack is used to receive the digital Scratch Box signal. Use the included stereo mini plugs to connect the Scratch Box to the to this jack. Be sure to use a dual stereo jack for proper functionality. For more information on the Scratch Box refer to the Scratch Box manual.

47.DRIVE 1 REMOTE JACK - Connect the supplied 8 pin din cable from this jack to the remote control's channel 1 remote connector. This will allow you to control the player functions with the remote unit.

48.DRIVE 1 DIGITAL OUT - This jack sends a digital stereo out signal. Use this connection to create near perfect copies of your disc to a Mini disc, CD-R, or any other recording device with a digital input.

49.DRIVE 1 AUDIO OUT R & L - These jacks send a left and right analog mono output signal. Use these jacks to send standard audio to a mixer or receiver. The red colored jack represents the right channel output and white jack represents the left channels output.