Asante Technologies 7000 user manual 10/100 8-Port XP Module, Installing a Gigabit module

Page 16
Power down the unit.
Power down the unit.

Installation

To install the Gigabit SX XP Module:

1

2 Remove the metal cover from the front of an empty expan- sion slot (located on the Switch’s front panel) using a small Phillips screwdriver.

3 Align the bottom of the Gigabit module with the rails on the inside of the expansion slot. See Figure 2-5.

 

 

 

Option Slot B

 

 

 

 

 

Switched Gigabit Ethernet Port

 

 

 

 

 

 

 

 

Link/Data

 

 

 

 

 

Power

 

 

Full Duplex/Collision

 

 

 

 

 

Tx

Rx

 

 

 

 

 

9

10

11

12

13

14

15

16

MII

 

 

 

 

 

 

 

 

Power

Figure 2-5 Installing a Gigabit module

4 Slide the module into the expansion slot until it stops, then push the module in until it seats with the connector.

5 Secure the module into place by tightening the screws on the module’s cover using a small Phillips screwdriver.

10/100 8-Port XP Module

Each Asanté 10/100Mbps 8-port expansion module adds another 8 ports to the Switch. Installation is easy.

To install the 10/100 8-Port XP Module:

1

2 Remove the metal cover from the front of an empty expan- sion slot (located on the Switch’s front panel) using a small Phillips screwdriver.

3 Align the bottom of the 8-port expansion module with the rails on the inside of the expansion slot.

4 Slide the module into the expansion slot until it stops, then push the module in until it seats with the connector.

5 Secure the module into place by tightening the screws on the module’s cover using a small Phillips screwdriver.

Page 2-4

Image 16
Contents User’s Manual Copyright Notice Trademarks Table of Contents LED Indicators Troubleshooting Specifications Technical SupportAbout This Manual Chapter Contents Document ConventionsIntroduction Introducing the FriendlyNET 7000 SeriesModel Numbering Convention Configuration OptionsFeatures Performance Features Switching TechnologySwitch Acts as a Bridge Between Network Segments Fast Ethernet and Gigabit Ethernet Technology Introduction Installation Package ContentsComponents FS7108FS7016 Base Unit Expansion ModulesGigabit SX XP Module Installing a Gigabit module 10/100 8-Port XP ModuleFX MII Module MII slotInstalling an MII module Mounting ConfigurationsDesktop Mounting Rack MountingCabling Requirements 11 Mounting the FS7000 in an equipment rackConnecting Network Devices Connecting a Computer to the SwitchConnecting a Hub or a Switch to the Asanté Switch Connecting a Hub with No Uplink Port to the SwitchCascading Multiple FS7000 Switches Powering on the SwitchVoltage Requirements Installation LED Indicators Power On LED Indicators MII Power LED100/10Mbps Operation LED LED Indicators for Port ConnectionsFull/Half Duplex LED Power LED LED Indicators on Gigabit SX ModuleLink/Data LED Full Duplex/Collision LED LED Indicators Troubleshooting A-2 Specifications FS7000 Series Physical and Environmental Specifications Gigabit SX XP Module Specifications B-4 Technical Support Contacting Technical SupportC-2 Asanté TECHNOLOGIES, INC., 821 FOX LANE, SAN JOSE, CA