Basic operation, Super bass, Tape direction memory

HOLD

E
	1
	4
	2
	3
	FF
	REW
	5 S-BASS
	+5 PHRASE
2
3	4

Playback starts from the front side. The OPE/BATT indicator lights up.

4 Adjust the volume.

Basic operation

Press the following buttons.

To fast forward	the FF button
To rewind	the REW button
To stop	the sbutton on the main unit
	the sRADIO OFF button on the remote conrol
To change the playback side	the d button during playback

•If you press the FF or REW button during playback, playback starts automatically when the end of the tape is reached.

Note

After you press a button, if “beep” is heard several times and then operation does not start, check to see that the batteries do not wear out.

Super bass

Press the 5 S-BASS button to emphasize the low frequencies. appears in the

display. Press the button again to resume the normal sound. disappears from the display.

To repeat a 5-second phrase

Press the +5 PHRASE button during playback. The tape is rewound to a point approximately *5 seconds before the point where the button was pressed and playback resumes automatically.

*The time may vary according to the playback point of the tape when the button is pressed.

Tape direction memory

The playback side does not change when the tape stops. The next time jl button is pressed, playback starts on the same side. However, playback starts from the front side of the tape after:

•The cassette holder is opened.

•The dry cell batteries are removed.

Caution

Do not force the cassette holder to open if the cassette cannot be taken out.

In this case, close the cassette holder once, press the jlbutton and after a few seconds press the sbutton.

When the tape stops completely, open the cassette holder.

NOTE

FOR USE IN THE U.S.A.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment and receiver.

–Connect the equipment into an outlet on circuit different from that to which the receiver is connected.

–Consult the dealer or an experienced radio/TV technician for help.

CAUTION

Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.