Installation Requirements
The Mesh Serial Modem will require the following in a typical installation:
•5 – 14.0 VDC Power.
•A suitable mounting location
•Antenna and RF cabling appropriate for use in the 2.4 GHz band.
WSM6300 Assembly
The external connection points on a WSM6300 unit are shown below.
•The power / serial connector interface is shown on the upper left corner below.
•The antenna port
•The transceiver MAC address is recorded on the label located on front side of the WSM unit. Record the MAC Address in the table in the WSM6300 MAC Addresses section of this document.
Figure 1. WSM6300 Assembly
2