Emerson Process Management GFC, MICRO manual Connectors, Part Numbers, Diminsions

Page 20

Vibration:

1g for 10-500 Hz on any axis per SAMA PMC-31-1 without

 

damage or impairment.

 

.5g for 150-2000Hz

RFI Susceptibility:

10V/meter – 80MHz to 1000MHz

3.3 CONNECTORS

3.3.1 Terminal Block TB1

3-Pin Terminal Block TB1 accommodates input power from the bulk DC source. TB1 could act as a power pass-through interface to an RTU (in lieu of connector TB3) (see Table 1).

3.3.2 Terminal Block TB3

3-Pin Terminal Block TB3 typically accommodates pass-through power to the associated ControlWave RTU but could act as the Loop Supply input power interface (in lieu of connector TB1) (see Table 1).

3.3.3 Terminal Block TB2

8-Pin Terminal Block TB2 accommodates distribution (four pairs of wiring terminals) of regulated +24Vdc loop power (see Table 2).

3.4 PART NUMBERS

400095-01-7 Snap Track Mount

721708-01-3 Panel Mount

721708-02-1 35mm DIN Rail Mount

3.5 DIMINSIONS

Dimensions are provided in Figure 6.

PIP-ControlWaveLS

Page - 11

Image 20
Contents Product Installation Guide IMPORTANT! Read Instructions Before Starting Warranty Phone MailBristol Inc Bristol Inc. Repair Authorization Form off-line completion Training Few Words About Bristol Inc 860 860 945-2213 FAXVisit our Site on the World Wide Web Training Courses PIP-ControlWaveLS Terminal Blocks General DescriptionLoop Supply Component Identification TB1 TB3 Regulated 24V Supply Distribution Connector TB2 Configuration Jumper JP1Power LED Fuse F1Loop Supply Installation Loop Supply MountingEncapsulated ControlWave Loop Supply Mounting Diagram Power Input and Pass-through Wiring Considerations Loop Supply WiringField I/O Wiring Considerations ControlWave Micro & EFM Loop Supply to I/O Module Wiring = GND = Power IN+ Operating Specifications Environmental SpecificationsDiminsions ConnectorsPart Numbers Loop Supply Dimensions Drawing ControlWave Loop Power Supply