PipeRider® Cable Modem User's Guide | HM200c/HM201c |
Installation: USB for Windows 98/2000/Me
Follow the steps below in the order given:
1.Connect the coaxial cable between the service provider's cable jack and the cable connector on the back of the modem. Be sure not to bend the center wire on the connector. Hand tighten both connectors.
2.Plug the DIN connector of the power supply cable into the Power connector on the back of the cable modem. Plug the power supply into a surge protected power source.
3.The USB drivers are located on this PipeRider Support CD. The CD must be in the
Insert the square plug of the USB cable into the USB port on the back of the cable modem. Insert the rectangular plug of the USB cable into the USB port on the back of the computer.
4.Once the cables are connected, the computer will automatically search for the USB driver specific to your operating system. If prompted for the location of the driver, enter the drive letter of your
5.Reboot your computer when prompted.
Note: From time to time, updates to USB drivers become available. After you've completed the installation of your cable modem, it is recommended that you visit the Ericsson PipeRider Internet site periodically to download
the latest version of the drivers.
Note: In the event of an electrostatic discharge (ESD) to the exposed metal surfaces of the cable modem, the USB port may become inoperable. If this occurs, disconnect and then reconnect the USB cable from the back of the cable modem. If this does not restore USB operation to the cable modem, power the modem off and on by unplugging the modem, waiting a minute, and then plugging it back in.